Search results
Results from the WOW.Com Content Network
The most common type of CVT uses a V-belt which runs between two variable-diameter pulleys. [2] The pulleys consist of two cone-shaped halves that move together and apart. The V-belt runs between these two halves, so the effective diameter of the pulley is dependent on the distance between the two halves of the pull
There are also mechanical designs for torque converters, many of which are similar to mechanical continuously variable transmissions or capable of acting as such as well. . They include the pendulum-based Constantinesco torque converter, the Lambert friction gearing disk drive transmission and the Variomatic with expanding pulleys and a belt dri
Ixion engine on a Komet motorised bicycle, ca. 1902. This system is used, for example, to drive the spools in some tape recorders.In a typical configuration, one of the cylinders is the axle of an electric motor, say 1 mm in diameter, while the other is a disk with a hard rubber rim, say 50 mm in diameter, yielding a 1:50 mechanical advantage.
Automated manual transmissions can be semi-automatic or fully-automatic in operation. Several different systems to automate the clutch and/or shifting have been used over the years, but they will generally use one of the following methods of actuation for the clutch and/or shifting: hydraulic or electro-hydraulic actuation, [12] electro-mechanical, [13] pneumatic, [6] [14] [15] electromagnetic ...
A dual-clutch transmission (DCT) (sometimes referred to as a twin-clutch transmission) is a type of multi-speed vehicle transmission system, that uses two separate clutches for odd and even gear sets. [1] The design is often similar to two separate manual transmissions with their respective clutches contained within one housing, and working as ...
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
This type of clutch is designed to partially disengage or "slip" when the rear wheel tries to drive the engine faster than it would run under its own power. The engine braking forces in conventional clutches will normally be transmitted back along the drive chain causing the rear wheel to hop, chatter or lose traction. [ 3 ]
An electrorheological clutch (ER clutch) comprises drive and driven members, generally parallel to each other, ...