Search results
Results from the WOW.Com Content Network
The most common type of CVT uses a V-belt which runs between two variable-diameter pulleys. [2] The pulleys consist of two cone-shaped halves that move together and apart. The V-belt runs between these two halves, so the effective diameter of the pulley is dependent on the distance between the two halves of the pull
It is marketed variously under the trade names TCT - Twin Clutch Transmission , Euro Twin Clutch Transmission , [2] TCSS - The Twin Clutch System [3] and Dual-Dry-Clutch Auto Transmission . Able to receive torque inputs of up to 350 N⋅m (260 lbf⋅ft), the transmission is the highest-torque transverse dual-dry-clutch application.(2012) [ 4 ...
There are also mechanical designs for torque converters, many of which are similar to mechanical continuously variable transmissions or capable of acting as such as well. . They include the pendulum-based Constantinesco torque converter, the Lambert friction gearing disk drive transmission and the Variomatic with expanding pulleys and a belt dri
Ixion engine on a Komet motorised bicycle, ca. 1902. This system is used, for example, to drive the spools in some tape recorders.In a typical configuration, one of the cylinders is the axle of an electric motor, say 1 mm in diameter, while the other is a disk with a hard rubber rim, say 50 mm in diameter, yielding a 1:50 mechanical advantage.
A dual-clutch transmission (DCT) (sometimes referred to as a twin-clutch transmission) is a type of multi-speed vehicle transmission system, that uses two separate clutches for odd and even gear sets. [1] The design is often similar to two separate manual transmissions with their respective clutches contained within one housing, and working as ...
One-way bearing combining sprags and bearing rollers in one race Sprags jam when driven and slide when in reverse. A sprag clutch is a one-way freewheel clutch.It resembles a roller bearing but, instead of cylindrical rollers, non-revolving asymmetric figure-eight shaped sprags, or other elements allowing single direction rotation, are used.
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
The output disks are connected to a gear, coupling, or pulley via drive cup. The clutch slips until the input and output RPMs are matched. This happens relatively quickly typically (0.2 - 2 sec). When the current is removed from the clutch, the armature is free to turn with the shaft.