Search results
Results from the WOW.Com Content Network
Two-inch port tube installed in the top of a Polk S10 speaker cabinet as part of a DIY audio project. This port is flared. Unlike closed-box loudspeakers, which are nearly airtight, a bass reflex system has an opening called a port or vent cut into the cabinet, generally consisting of a pipe or duct (typically circular or rectangular cross section).
A transmission line loudspeaker is a loudspeaker enclosure design which uses the topology of an acoustic transmission line within the cabinet, compared to the simpler enclosures used by sealed (closed) or ported (bass reflex) designs.
These designs can be considered a mass-loaded transmission line design or a bass reflex design, as well as a quarter wave enclosure. [39] Quarter wave resonators have seen a revival as commercial applications with the onset of neodymium drivers that enable this design to produce relatively low bass extensions within a relatively small speaker ...
This was a 26-watt tube amplifier with a single 15" speaker. In 1954, the Bassman was redesigned to use four 10" speakers. This speaker cabinet was an open-back design; as such, it had poor low-frequency efficiency and was prone to blowing speakers when used for bass because of the lack of damping.
This model soon became the SM-400. SWR then pursued development of a speaker cabinet to accompany its amps. In 1986, SWR released the Goliath, a 4 x 10" full-range speaker cabinet with a built-in horn tweeter, a first for bass cabinets. The company's name was changed to SWR Sound Corporation on 1 December 1997 as part of a restructuring plan.
This article lists manufacturers of bass amplifiers, loudspeakers, and other amplification-related items such as preamplifiers. The amplifiers and loudspeakers used to amplify bass instruments (e.g., the bass guitar, double bass and similar instruments) are distinct from other types of amplification systems due to the particular challenges associated with low-frequency sound reproduction.
The hole below the lowest woofer is a port for a bass reflex system.. A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network).
The weight of the cone of the passive radiator should be approximately equivalent to the mass of the air that would have filled the port which might have been used for that design. If the passive radiator's acoustic mass equals that of the port, and the passive radiator's compliance is negligible, then the frequency response behaviour of these ...