Search results
Results from the WOW.Com Content Network
MIL-STD-129. MIL-STD-129 standard is used for maintaining uniformity while marking military equipment and supplies that are transported through ships. This standard has been approved to be used by the United States Department of Defense and all other government agencies. Items must be marked for easy identification before they are transported.
MIL-STD-276, Standard for vacuum impregnation of porous metal castings and powdered metal components [16] MIL-STD-348 , "Radio Frequency (RF) Connector Interfaces" [ 17 ] MIL-STD 461 , "Requirements for the control of electromagnetic interference characteristics of subsystems and equipment" [ 18 ]
MIL-STD-130 describes the materials allowed, minimum text size and fonts, format, syntax and rules for identifying marks on a part, where to locate this marking plus exceptions and unique situations, such as vehicle identification numbers, cell phone IDs, etc. Other non-identifying markings—such as "this end up"—are covered under MIL-STD-129.
IUID - Item Unique Identification is the strategic system implemented by the DoD to enhance the traceability of the property. UID - Unique Identification, the term UID is commonly used for different things and sometimes used in place of IUID, and thus can be a source of confusion. Generally, "The UID" refers to the physical mark on the asset or ...
It is preferred that articles in this category be listed by publishing identifier (MIL-STD-####) for consistency. Pages in category "Military of the United States standards" The following 46 pages are in this category, out of 46 total.
General Electric. AN/GKA-10. Converter Group, part of AN/GPA-73 Radar Course Directing Group air defense command, control, and coordination system. Air Defense Command. RCA Corporation. AN/GKA-11. Converter Group, part of AN/GPA-73 Radar Course Directing Group air defense command, control, and coordination system.
This is the velocity at which 50 percent of the shots go through and 50 percent are stopped by the armor. US military standard MIL-STD-662F V50 Ballistic Test define a commonly used procedure for this measurement. The goal is to get three shots that penetrate that are slower than a second faster group of three shots that are stopped by the armor.
MIL-STD-810 is maintained by a Tri-Service partnership that includes the United States Air Force, Army, and Navy. [2] The U.S. Army Test and Evaluation Command, or ATEC, serves as Lead Standardization Activity / Preparing Activity, and is chartered under the Defense Standardization Program (DSP) with maintaining the functional expertise and serving as the DoD-wide technical focal point for the ...