Search results
Results from the WOW.Com Content Network
In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.
hazard lights switch 85c hazard sound on Switches 81 opener 81a 1 out 81b 2 out 82 lock in 82a 1st out 82b 2nd out 82z 1st in 82y 2nd in 83 multi position switch, in 83a out position 1 83b out position 2 Relay; 85 relay coil - Important if relay coil has flyback diode in parallel 86 relay coil + Important if relay coil has diode in parallel
U.S. standard 7-inch headlamp combining low and high beam with turn signal lights below on a 1949 Nash 600 Glass-covered 5¾" sealed beam headlamps on a 1965 Chrysler 300 Rectangular sealed-beam headlamps with turn signal light below on a 1979 AMC Concord. Headlight design in the U.S. changed very little from 1940 to 1983. [7] [16]
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
Standardized type numbers are used by manufacturers to identify bulbs with the same specifications. Bases may be bayonet-type with one or two contacts, plastic or glass wedges, or dual wire loops or ferrules used on tubular "festoon" lights. Screw-base lights are never used in automobile applications due to their loosening under vibration.
In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...
Household wiring does not usually use three-phase supplies and the clash only occurs in three-phase systems. Wiring to the old standard can be detected by use of a red wire. The new standard colour code does not use red. Where new wiring is mixed with old, cables must be clearly marked to prevent interchange of phase and neutral.
The first types of small modular telephone connectors were created by AT&T in the mid-1960s for the plug-in handset and line cords of the Trimline telephone. [1] Driven by demand for multiple sets in residences with various lengths of cords, the Bell System introduced customer-connectable part kits and telephones, sold through PhoneCenter stores in the early 1970s. [2]