enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...

3. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   In the early 1930s American Henry F. Phillips popularized the Phillips-head screw, with a cross-shaped internal drive. [27] Later improved -head screws were developed, more compatible with screwdrivers not of the exactly right head size: Pozidriv and Supadriv. Phillips screws and screwdrivers are to some extent compatible with those for the ...

4. Screwdriver - Wikipedia

   en.wikipedia.org/wiki/Screwdriver

   The cross in the screw head is sharper and less rounded than a Phillips, and the bit has 45° flukes and a sharper, pointed end. Also, the Phillips screw slot is not as deep as the Reed and Prince slot. [19] [20] In theory, different size R&P screws fit any R&P bit size. [21]

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...

6. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   Many screws used in electrical applications (for example, a typical NEMA 5-15R, breaker screws, and conduit screws) use a combination of a slotted/Phillips/Robertson screw head. A few tool manufacturers make bits to engage this screw head better than the traditional Phillips allowing for more torque before camout, for example, the C1 and C2 ...

7. Yankee screwdriver - Wikipedia

   en.wikipedia.org/wiki/Yankee_screwdriver

   adapters to adapt push drill size drill point sets to the three sizes of screwdriver chuck size; countersinks; screwdriver tips holding with screw holding feature; Phillips screwdriver tips in various sizes (Ph#1 to Ph#3 in 5/16" and 9/32" shank models, Ph#1 and Ph#2 sizes only for the 7/32" shank models)

8. AOL

   search.aol.com

   The search engine that helps you find exactly what you're looking for. Find the most relevant information, video, images, and answers from all across the Web.

9. Henry F. Phillips - Wikipedia

   en.wikipedia.org/wiki/Henry_F._Phillips

   Phillips screw head. Henry Frank Phillips (June 4, 1889 – April 13, 1958) was an American businessman from Portland, Oregon. The Phillips-head ("crosshead") screw and screwdriver are named after him. [1] The importance of the crosshead screw design lies in its self-centering property, useful on automated production lines that use powered ...