Search results
Results from the WOW.Com Content Network
The 4L80-E uses two shift solenoids, initially called Shift Solenoid A and Shift Solenoid B; they were later changed to comply with OBD-II regulations to 1-2 shift solenoid and 2-3 shift solenoid. By activating and deactivating the solenoids in a predetermined pattern by the PCM, four distinct gear ratios can be achieved.
Original file (1,554 × 1,133 pixels, file size: 138.83 MB, MIME type: application/pdf, 818 pages) This is a file from the Wikimedia Commons . Information from its description page there is shown below.
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
The 4L80E (and its successor 4L85E) was the first Hydramatic to incorporate electronic controls — almost all of the THM400/3L80/3L80HD's components are interchangeable. Transmission fluid cooler line connections are found on the right-hand side of the THM400. The lower connection is the cooler feed, and the upper connection is the return. [1]
All engines were paired with a 4-speed overdrive automatic transmission, carried over from the previous van; the 1500 and light-duty 2500 series (below 8,500 pounds GVWR) used a 4L60E transmission while the heavy-duty 2500 and 3500 series (above 8,500 pounds GVWR) used a heavier-duty 4L80E unit.
Borg-Warner R-11 overdrive - 3-speed manual transmission with electric overdrive Ford used them up until 1975 in trucks. Borg-Warner T-50 transmission — 5-speed longitudinal manual - used by GM in its RWD H-Body cars and a few other limited light duty applications from 1976 to 1978;
A park by wire system engages the parking pawl of a transmission using electrical means, without the traditional mechanical system which involves linkages between the gear shifter and the transmission. Park-by-wire can be considered a part of a shift by wire system, as it shifts the transmission into park mode. [1]
An automated manual transmission may include a fully automatic mode where the driver does not need to change gears at all. [24] These transmissions can be described as a standard manual transmission with an automated clutch and automated gear shift control, allowing them to operate in the same manner as traditional automatic transmissions.