Search results
Results from the WOW.Com Content Network
Murphy oil pressure gauges with switches that activate on low pressure. Oil pressure is an important factor in the longevity of most internal combustion engines. [1] With a forced lubrication system (invented by Frederick Lanchester), oil is picked up by a positive displacement oil pump and forced through oil galleries (passageways) into bearings, such as the main bearings, big end bearings ...
Hydrolock (a shorthand notation for hydrostatic lock or hydraulic lock) is an abnormal condition of any device which is designed to compress a gas by mechanically restraining it caused by a liquid entering the device.
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
Crankcase dilution occurs when the fuel oil from the engine gets into the lube oil of the engine. This can be caused by the walls being wetted due to the fuel condensing in the cylinder. If the engine is cold, or there is an excess amount of cooling around the cylinder, [ 1 ] the fuel oil will condense and have a higher chance to end up in the ...
The system features an oil pressure operated device attached to the back of the standard gearbox operating on the gearbox output shaft. Through a system of oil pressure, solenoids and pistons, the overdrive would drop the revs on whatever gears it was used on by 22% (.778).
The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...
Alfa Romeo's variator is a cylindrical chamber that contains a pressure chamber and piston along with helical splines. Engine oil pressure, moves the internal piston which rotates slightly due to the helical splines and advances the inlet valve timing by 25 degrees. Oil flow to the variator is controlled by a solenoid valve.
In the tire factory, the tire and wheel are mounted on a balancing machine test wheel, the assembly is rotated at 100 r/min (about 5–7 m/s (18–25 km/h; 11–16 mph) with recent high sensitivity sensors) or higher, 300 r/min (about 25–27 m/s (90–97 km/h; 56–60 mph) with typical low sensitivity sensors), and forces of unbalance are ...