enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   The cage has two wings that when compressed allow the cage to be inserted into the square holes Clip-on nut: J-nut or U-nut, sheet metal nut, speed nut (ambiguously) Designed to be clipped to sheet metal Coupling nut: Extension nut A threaded fastener for joining two male threads, most commonly a threaded rod,[1][2] but also pipes Flange nut ...

3. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   Hexagon slotted nuts and castle nuts with metric coarse and fine pitch thread – Product grades A and B: Active: DIN 935-2: M42 to M160x6 hexagon head nuts; product grade B: Active: DIN 935-3: Hexagon slotted nuts with metric coarse pitch thread – Product grade C: Active: DIN 936: M8 to M52 and M8x1 to M52x3 hexagon thin nuts; product grades ...

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A common type of this style fitting is a "hex bushing" with a hex head for installation with a pipe wrench. A double-tapped bushing is more compact than a reducer but not as flexible. While a double-tapped bushing has a more minor female thread concentric to a larger male thread (and thus couples a smaller male end to a larger female), a ...

5. Flange nut - Wikipedia

   en.wikipedia.org/wiki/Flange_nut

   A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.

6. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole ...

7. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Allow nuts to be attached to what is really a screw. Hex bolt - Bolt with a hexagonal head and threaded shank. Section immediately under head may be unthreaded for fastening thicker materials. J bolt - Bolt shaped like the letter J, used for tie downs. Only the straight section is threaded for a nut.