Ads
related to: dana 30 front axle specsebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions. 2011 Jeep Dana 30 differential Jeep Dana 30
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
1996–1999: Dana 30, high pinion, reverse cut, 297x/760 universal joint, 27-spline axle shafts 2000–2001: Dana 30, low pinion, standard cut, 297x/760 universal joint, 27-spline axle shafts 1985–2001: straight non-driven front axle for two-wheel drive only
Front axle. International Harvester. 1975 1300 Camper Special ← A Dana BOM number series was created but no record of any Dana 60 front axles being used by International has been proven. Chevrolet 1977–1991 1Ton (K30/V30) 1984–1988 Commercial Utility Cargo Vehicle; 2019–2020 Medium Duty; Dodge 1975–2002 3 ⁄ 4-ton (D-600/W-250/2500)
The 258 cu in (4.2 L) AMC straight-6 engine remained available as an option, but the transmission was changed from the Tremec T-150 three-speed to a Tremec T-176 close-ratio four-speed. The Dana 30 front axle was retained, but the locking hubs were changed to a five-bolt retaining pattern versus the older six-bolt.
Both companies used Dana 70 front axles until the mid-1970s (Dodge W300 pickup up until 1978, discontinued in 1979). All of these Dana 70 front axles were closed knuckle, with king pins and had a GAWR of 6000 lbs. Like the rear Dana 70 axles, the Dana 70 front axle started out with 23 spline axle shafts and then went to 35 spline axle shafts.
Ads
related to: dana 30 front axle specsebay.com has been visited by 1M+ users in the past month