Search results
Results from the WOW.Com Content Network
The 6R is a 6-speed automatic transmission for longitudinal engine placement in rear-wheel drive vehicles. It is based on the ZF 6HP26 transmission [1] and has been built under license by the Ford Motor Company at its Livonia Transmission plant in Livonia, Michigan.
The gear ratio also determines the transmitted torque. The torque ratio TR AB of the gear train is defined as the ratio of its output torque to its input torque. Using the principle of virtual work, the gear train's torque ratio is equal to the gear ratio, or speed ratio, of the gear
The "70" may also refer to the transmission's torque capacity after torque converter multiplication which occurs at low RPM when the torque converter is more "elastic". 4R70W indicates 4 gears, Rear wheel drive and Wider gear ratio compared to the AODE. The gear ratios are: First: 2.84 :1; Second: 1.55 :1; Third: 1.00 :1; Overdrive: 0.70 :1 ...
After its introduction in 1984, the Justy was also available with 4WD and thus a different gearbox. The gear ratios for this gearbox were altered slightly. In 1994 the normal/FWD gearbox was dropped; one could only get a 4WD gearbox by then. Gear ratios: 1st 3.071 2nd 1.695 3rd 1.137 4th .771 5th .631, Rev 3.461 Final 5.200
The "MN4" 4T40E is able to handle vehicles up to 4000 lb (1814 kg) GVWR. The final drive ratio can vary depending on the car's curb weight and3wweteeengine power output. 3.91, 3.63, 3.29, 3.05, 3.69, and 3.42 are all of the available ratios used in the 4T40 (and 4T45) transmission; Made possible by using combinations selected from 3 different sprocket combinations (32/38, 35/35, 33/37) and 2 ...
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
1st and 2nd are low ratios like in the W56 for use to get a heavy vehicle moving. 3rd ratio is the same as in the W57/W58 for a lower rpm drop between 3rd & 4th useful in high-speed acceleration. 4th is direct 1:1 as per design in these boxes. 5th seems to be the base W55 overdrive ratio. Ratios: First Gear: 3.954:1; Second Gear: 2.141:1
The 8HP 70 transmission with the gearset 4 in 23-85-teeth-configuration was the pilot series and therefore without generation designation. It was first used in the BMW 7 Series (F01) 760Li, has a torque handling limit of 700 N⋅m (516 lb⋅ft), and weighs 87 kg (192 lb).