Search results
Results from the WOW.Com Content Network
4-port 10BASE-T Ethernet hub with selectable MDI-X/MDI port 8-port Ethernet hub with one 10BASE2 connector and eight 10BASE-T ports. An Ethernet hub, active hub, network hub, repeater hub, multiport repeater, or simply hub [a] is a network hardware device for connecting multiple Ethernet devices together and making them act as a single network segment.
A hub is a component of a network with a high-degree node. Hubs have a significantly larger number of links in comparison with other nodes in the network. The number of links for a hub in a scale-free network is much higher than for the biggest node in a random network, keeping the size N of the network and average degree <k> constant. The ...
2NF—second normal form; 3GL—third-generation programming language; 3GPP—3rd Generation Partnership Project – 3G comms; 3GPP2—3rd Generation Partnership Project 2; 3NF—third normal form; 386—Intel 80386 processor; 486—Intel 80486 processor; 4B5BLF—4-bit 5-bit local fiber; 4GL—fourth-generation programming language; 4NF ...
The physical layer is responsible for the transmission and reception of unstructured raw data between a device, such as a network interface controller, Ethernet hub, or network switch, and a physical transmission medium. It converts the digital bits into electrical, radio, or optical signals.
Hub with three MDI-X ports and one switchable port, circa 1998 Switch showing one logical port, 16, with two physical ports, one in each conductor arrangement: MDI-X (the norm for a hub or switch), labelled 16x, and MDI, labelled Uplink, for connecting to another hub or switch with a normal straight-through cable
An ATM network interface in the form of an accessory card. A lot of network interfaces are built-in. A network interface controller (NIC) is computer hardware that connects the computer to the network media and has the ability to process low-level network information. For example, the NIC may have a connector for plugging in a cable, or an ...
The routers in an Ethernet or Frame Relay network select a designated router (DR) and a backup designated router (BDR) which act as a hub to reduce traffic between routers. OSPF uses both unicast and multicast transmission modes to send "hello" packets and link-state updates.
In contrast to an Ethernet hub, there is a separate collision domain on each switch port. This allows computers to have dedicated bandwidth on point-to-point connections to the network and also to run in full-duplex mode. Full-duplex mode has only one transmitter and one receiver per collision domain, making collisions impossible.