Search results
Results from the WOW.Com Content Network
Message Signaled Interrupts (MSI) are a method of signaling interrupts, using special in-band messages to replace traditional out-of-band signals on dedicated interrupt lines. While message signaled interrupts are more complex to implement in a device, they have some significant advantages over pin-based out-of-band interrupt signalling, such ...
The Message Signaled Interrupts (MSI) feature of the PCI 2.2 and later specifications cannot be used without the local APIC being enabled. [8] Use of MSI obviates the need for an I/O APIC. Additionally, up to 224 interrupts are supported in MSI mode, and IRQ sharing is not allowed. [9]
High speed mode is still designed to reduce power usage due to its low voltage signaling and parallel transfer ability. The communication protocol describes two sets of instructions. The Display Command Set (DCS) is a set of common commands for controlling the display device, and their format is specified by the DSI standard.
The most striking difference between MESI and MSI is the extra "exclusive" state present in the MESI protocol. This extra state was added as it has many advantages. When a processor needs to read a block that none of the other processors have and then write to it, two bus transactions will take place in the case of MSI. First, a BusRd request ...
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
The Advanced Host Controller Interface (AHCI) is a technical standard defined by Intel that specifies the register-level interface of Serial ATA (SATA) host controllers in a non-implementation-specific manner in its motherboard chipsets.
Seven countries, an ocean and over a thousand miles stand between them and their dreams for a future
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.