enow.com Web Search

  1. Ads

    related to: very small #2 metal screws for plastic assembly and repair tool holder

Search results

  1. Results from the WOW.Com Content Network
  2. List of screw and bolt types - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_and_bolt_types

    The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...

  3. 3-pronged parts retriever - Wikipedia

    en.wikipedia.org/wiki/3-Pronged_Parts_Retriever

    Three metal wires protrude from the other end, each sprung to bend outwards, away from the tube's axis, but with their tips bent inwards to form teeth. The push-button drives the wires down the tube, where their natural springiness causes them to spread further outwards, opening the teeth.

  4. Self-tapping screw - Wikipedia

    en.wikipedia.org/wiki/Self-tapping_screw

    Self-tapping screws can be divided into two classes: [3] those that displace material (especially plastic and thin metal sheets) without removing it, known as "thread-forming" self-tapping screws, and self-tappers with sharp cutting surfaces that remove the material as they are inserted, termed "thread-cutting" self-tapping screws.

  5. Set screw - Wikipedia

    en.wikipedia.org/wiki/Set_screw

    Hardened set screws often leave a plastic deformation, in the form of a circular or semicircular mark, in the shaft that the screw sets against. This has both pros and cons. On the pro side, such deformation increases the holding power (torque resistance) of the joint, as the screw is essentially "making its own detent" on a small but effective ...

  6. Molly (fastener) - Wikipedia

    en.wikipedia.org/wiki/Molly_(fastener)

    Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...

  7. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  1. Ads

    related to: very small #2 metal screws for plastic assembly and repair tool holder