Search results
Results from the WOW.Com Content Network
An older range extender will not be able to repeat the signal of a newer generation router. Security encryption compatibility also matters and must be at the same level of compatibility for the signal to be extended. For example, an older range extender that supports WEP and WPA will not be able to boost a WPA2-encrypted signal from a router.
That is, it is possible to reach any subscriber with any ADSL speed if one uses multiple loop extenders. A repeater can either be an amplifier or a re-generator. Amplifiers increase the signal level of the analog transmission signal; re-generators demodulate the signal to binary, then re-modulate it into the original transmission frequency.
Long-range Wi-Fi is used for low-cost, unregulated point-to-point computer network connections, as an alternative to other fixed wireless, cellular networks or satellite Internet access. Wi-Fi networks have a range that's limited by the frequency, transmission power, antenna type, the location they're used in, and the environment. [ 1 ]
Wi-Fi over Coax is a technology for extending and distributing Wi-Fi signals via coaxial cables.As an in-building wireless solution, Wi-Fi over Coax can make use of existing or new cabling with native impedance of 50 Ω shared by a Wi-Fi access point, cabling run, and antenna.
Local remote KVM extender design allows users to control computer equipment up to 1,000 feet (300 m) away from the user consoles (keyboard, monitor and mouse). They require a direct cable connection from the computer to the KVM switch to the console [ 10 ] and include support for standard category 5 cabling between computers and users ...
An Ethernet extender (also network extender or LAN extender) is any device used to extend an Ethernet or network segment beyond its inherent distance limitation which is approximately 100 metres (330 ft) for most common forms of twisted pair Ethernet. These devices employ a variety of transmission technologies and physical media (wireless ...
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
Consumer IR, consumer infrared, or CIR is a class of devices employing the infrared portion of the electromagnetic spectrum for wireless communications. [citation needed] CIR ports are commonly found in consumer electronics devices such as television remote controls, PDAs, laptops, computers, and video game controllers.