Search results
Results from the WOW.Com Content Network
Limiting the speed of data sent by a data originator (a client computer or a server computer) is much more efficient than limiting the speed in an intermediate network device between client and server because while in the first case usually no network packets are lost, in the second case network packets can be lost / discarded whenever ingoing data speed overcomes the bandwidth limit or the ...
is the rate of transmission (say, in bits per second). Most packet switched networks use store-and-forward transmission at the input of the link. A switch using store-and-forward transmission will receive (save) the entire packet to the buffer and check it for CRC errors or other problems before sending the first bit of the packet into the ...
In data communications, the bandwidth-delay product is the product of a data link's capacity (in bits per second) and its round-trip delay time (in seconds). [1] The result, an amount of data measured in bits (or bytes), is equivalent to the maximum amount of data on the network circuit at any given time, i.e., data that has been transmitted but not yet acknowledged.
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
A method of connection to the internet using existing copper phone lines using a modem on the client's end to send information at a slow speed, normally reaching maximum speed at about 56 kbit/s. This technology uses the voice spectrum of the telephone lines to transmit data using a system of sounds that only the receiving modem or ISP understand.
The packet transmission time in seconds can be obtained from the packet size in bit and the bit rate in bit/s as: Packet transmission time = Packet size / Bit rate. Example: Assuming 100 Mbit/s Ethernet, and the maximum packet size of 1526 bytes, results in Maximum packet transmission time = 1526×8 bit / (100 × 10 6 bit/s) ≈ 122 μs
The consumed bandwidth in bit/s, corresponds to achieved throughput or goodput, i.e., the average rate of successful data transfer through a communication path.The consumed bandwidth can be affected by technologies such as bandwidth shaping, bandwidth management, bandwidth throttling, bandwidth cap, bandwidth allocation (for example bandwidth allocation protocol and dynamic bandwidth ...
Groups like Free Press, Consumer Federation of America, and Consumers Union argue that the ISPs have no reason to remove bottlenecks from the network. The ISPs can charge more money to content providers to push past the Internet bottleneck. However, Free Press argues that ISPs could alleviate bottlenecks for all by increasing available ...