Search results
Results from the WOW.Com Content Network
Casing depths, well control options, formation fracture pressures and limiting fluid weights may be based on this information. To determine formation strength and integrity, a Leak Off Test (LOT) or a Formation Integrity Test (FIT) may be performed. The FIT is: a method of checking the cement seal between the casing and the formation.
The tubing may also have flow control mechanism. Single-well concentric kill string: within the well a small diameter concentric kill string is used to circulate kill fluids when needed. Single-well 2-tubing completion: in this instance 2 tubing strings are inserted down 1 well. They are connected at the lower end by a circulating head.
This offers well control capabilities beyond those normally possible with drill pipe, and gives the ability to drill underbalanced. Instead of rotating the drill bit by using a rotary table or top drive at the surface, it is turned by a downhole MUD MOTOR, powered by the motion of drilling fluid pumped from surface. Drilling which is powered by ...
In this well, the outside casing of the 'B' annulus is 13 + 3 ⁄ 8 in (340 mm) N80 grade with a weight of 68 lb⋅ft (92 N⋅m) −1. The burst pressure of this casing is 5020 psi. 1.2 sg brine produces a pressure gradient of 0.52 psi.ft −1 (see Well kill for the mathematical basics of hydrostatic heads). Therefore, the column of brine ...
L09 Occupant Lighting Control, providing individual control of light for one per 60 sq.m. or one per 10 occupants will be received 1 point, but if there are one per 30 sq.m. or one per 5 occupants, then it will be received 2 points, with the project has lighting control in each zone was setup at least three lighting levels, able to change group ...
Casing Diameters of a Borehole Casing Diagram premium gas tight connections on a casing string. Casing is a large diameter pipe that is assembled and inserted into a recently drilled section of a borehole. Similar to the bones of a spine protecting the spinal cord, casing is set inside the drilled borehole to protect and support the wellstream.
Performed after the well is cased, cased hole drill stem testing uses a retrievable production packer that is set above the zone of interest. The well is then flow tested through perforations in the casing. The two types of cased hole testing are pressure operated and mechanically operated.
The primary purpose of a wellhead is to provide the suspension point and pressure seals for the casing strings that run from the bottom of the hole sections to the surface pressure control equipment. [1] While drilling the oil well, surface pressure control is provided by a blowout preventer (BOP).