enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Torque tester - Wikipedia

   en.wikipedia.org/wiki/Torque_tester

   A key component of modern torque testers is the digital display. A digital display is used to measure the output signal from the transducer and calculates that reading into a torque value that is displayed on screen. In most cases the display and transducer are contained together inside a housing. This is known as a "Desktop Torque Tester".

3. Proto (tools) - Wikipedia

   en.wikipedia.org/wiki/Proto_(tools)

   Proto Tools (formally Stanley Proto) is an American industrial hand tool company. Founded as Plomb , it is presently a division of Stanley Black & Decker . The company is credited with creating the first combination wrench in 1933.

4. Cap torque tester - Wikipedia

   en.wikipedia.org/wiki/Cap_Torque_Tester

   The cap torque tester is used in the packaging industry to measure the opening or closing torque of the screw cap. Proper torque is required for the cap to perform its functions of maintaining a tight seal. [1] It is a piece of specific quality control equipment that can be placed on the production line or in the laboratory. Several designs ...

5. Prony brake - Wikipedia

   en.wikipedia.org/wiki/Prony_brake

   The torque is then related to the lever length, shaft diameter and measured force. The device is generally used over a range of engine speeds to obtain power and torque curves for the engine, since there is a non-linear relationship between torque and engine speed for most engine types. Power output in SI units may be calculated as follows:

6. Hydraulic torque wrench - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_torque_wrench

   A hydraulic torque wrench is significantly quieter, lighter weight and more accurate than pneumatic impact wrenches capable of similar torque output, making it an appealing alternative for many users to the very loud and cumbersome impact wrenches or torque multipliers which were formerly the only viable option for working with very large nuts ...

7. Direct torque control - Wikipedia

   en.wikipedia.org/wiki/Direct_torque_control

   Thus it is not possible to control the motor if the output frequency of the variable frequency drive is zero. However, by careful design of the control system it is possible to have the minimum frequency in the range 0.5 Hz to 1 Hz that is enough to make possible to start an induction motor with full torque from a standstill situation. A ...