Search results
Results from the WOW.Com Content Network
The charts are marked with World Geographic Reference System or GEOREF grids, and at the center of each grid square a number shows the elevation (MSL) of the highest obstacle within that grid (the maximum elevation figure or MEF). Thus a pilot is alerted of how high he must fly while traversing that grid to assure clearance of all possible ...
The FAA states "The height–velocity diagram or H/V curve is a graph charting the safe/unsafe flight profiles relevant to a specific helicopter. As operation outside the safe area of the chart can be fatal in the event of a power or transmission failure it is sometimes referred to as the dead man's curve."
An aeronautical chart is a map designed to assist in the navigation of aircraft, much as nautical charts do for watercraft, or a roadmap does for drivers. Using these charts and other tools, pilots are able to determine their position, safe altitude, best route to a destination, navigation aids along the way, alternative landing areas in case of an in-flight emergency, and other useful ...
The rule affected only those aircraft operating under IFR when in level flight above 3,000 ft above mean sea level, or above the appropriate transition altitude, whichever is the higher, and when below FL195 (19,500 ft above the 1013.2 hPa datum in the UK, or with the altimeter set according to the system published by the competent authority in ...
Helicopters are capable of flying with no more than a few feet of clearance below the helicopter's skids or wheels. Fast jets are more constrained and at a typical low-flying speed of 450 knots (830 km/h), 200 feet (61 m) is not unusual and 50 feet (15 m) is possible in relatively flat terrain.
En-route charts are divided into high and low versions, with information on airways and navaids for high- and low-altitude flight, respectively. The division between low altitude and high altitude is usually defined as the altitude that marks transition to flight levels (in the United States, this is taken to be 18,000 feet MSL by convention).
VFR requires a pilot to be able to see outside the cockpit to control the aircraft's altitude, navigate, and avoid obstacles and other aircraft. [3] Governing agencies establish specific requirements for VFR flight, including minimum visibility, and distance from clouds, to ensure that aircraft operating under VFR are visible from enough distance to ensure safety.
In aviation, minimum reception altitude (MRA) is the lowest altitude on an airway segment where an aircraft can be assured of receiving signals from off-course navigation aids like VOR that define a fix. An MRA is determined by FAA flight inspection traversing an entire route of flight to establish the minimum altitude the navigation signal can ...