Search results
Results from the WOW.Com Content Network
Plastic optical fiber (POF) or polymer optical fiber is an optical fiber that is made out of polymer. Similar to glass optical fiber, POF transmits light (for illumination or data) through the core of the fiber. Its chief advantage over the glass product, other aspect being equal, is its robustness under bending and stretching.
An optical fiber, or optical fibre, is a flexible glass or plastic fiber that can transmit light [a] from one end to the other. Such fibers find wide usage in fiber-optic communications , where they permit transmission over longer distances and at higher bandwidths (data transfer rates) than electrical cables.
MOST uses plastic optical fiber (POF) with a core diameter of 1 mm as transmission medium, in combination with light emitting diodes (LEDs) in the red wavelength range as transmitters. MOST25 only uses an optical physical layer. MOST50 and MOST150 support both optical and electrical physical layers.
Fiber-optic communication is a form of optical communication for transmitting information from one place to another by sending pulses of infrared or visible light through an optical fiber. [ 1 ] [ 2 ] The light is a form of carrier wave that is modulated to carry information. [ 3 ]
Hard-clad silica (HCS) or polymer-clad fiber (PCF) is an optical fiber with a core of silica glass (diameter: 200 μm) and an optical cladding made of special plastic (diameter: 230 μm). In contrast to all-silica fiber , the core and cladding can be separated from each other.
In telecommunications and fiber optics, a plastic-clad silica fiber or polymer-clad silica fiber (PCS) is an optical fiber that has a silica-based core and a plastic cladding. [1] The cladding of a PCS fiber should not be confused with the polymer overcoat of a conventional all-silica fiber.
Multi-mode links can be used for data rates up to 800 Gbit/s. Multi-mode fiber has a fairly large core diameter that enables multiple light modes to be propagated and limits the maximum length of a transmission link because of modal dispersion. The standard G.651.1 defines the most widely used forms of multi-mode optical fiber.
Most optical fiber connectors are spring-loaded, so the fiber faces are pressed together when the connectors are mated. The resulting glass-to-glass or plastic-to-plastic contact eliminates signal losses that would be caused by an air gap between the joined fibers.