Search results
Results from the WOW.Com Content Network
Fluke Corporation is an American manufacturer of industrial test, measurement, and diagnostic equipment, including electronic test equipment. It was started in 1948 by John Fluke while he was employed at General Electric .
Any meter will load the circuit under test to some extent. For example, a multimeter using a moving coil movement with full-scale deflection current of 50 microamps (μA), the highest sensitivity commonly available, must draw at least 50 μA from the circuit under test for the meter to reach the top end of its scale. This may load a high ...
The formal definition of calibration by the International Bureau of Weights and Measures (BIPM) is the following: "Operation that, under specified conditions, in a first step, establishes a relation between the quantity values with measurement uncertainties provided by measurement standards and corresponding indications with associated measurement uncertainties (of the calibrated instrument or ...
Most frequency counters work by using a counter, which accumulates the number of events occurring within a specific period of time.After a preset period known as the gate time (1 second, for example), the value in the counter is transferred to a display, and the counter is reset to zero.
A calibration curve plot showing limit of detection (LOD), limit of quantification (LOQ), dynamic range, and limit of linearity (LOL).. In analytical chemistry, a calibration curve, also known as a standard curve, is a general method for determining the concentration of a substance in an unknown sample by comparing the unknown to a set of standard samples of known concentration. [1]
A key component of modern torque testers is the digital display. A digital display is used to measure the output signal from the transducer and calculates that reading into a torque value that is displayed on screen. In most cases the display and transducer are contained together inside a housing. This is known as a "Desktop Torque Tester".
If the micrometer measures 0.7503 inch, then it is out of calibration. Cleanliness and low (but consistent) torque are especially important when calibrating—each tenth (that is, ten-thousandth of an inch), or hundredth of a millimetre, "counts"; each is important.
Despite continuing demand from customers, production was stopped in 2008, reportedly due to increasing problems with suppliers of mechanical parts. [16] The last meter to leave the factory was an AVOmeter Eight Mk 7 (Serial Number 6110-610/081208/5166) which was presented in February 2010 to the winner of a competition run by the Megger company.