Search results
Results from the WOW.Com Content Network
A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or copy of the file. The throughput is then calculated by dividing the file size by the time to get the throughput in megabits, kilobits, or bits per second.
Some drawbacks of the two two-port approach follow, intended for the attentive reader. Figure 7 shows the small-signal schematic with the main amplifier and the feedback two-port in shaded boxes. The feedback two-port satisfies the port conditions: at the input port, I in enters and leaves the port, and likewise at the output, I out enters and ...
The individual signals on a serial port are unidirectional and when connecting two devices, the outputs of one device must be connected to the inputs of the other. Devices are divided into two categories: data terminal equipment (DTE) and data circuit-terminating equipment (DCE). A line that is an output on a DTE device is an input on a DCE ...
DisplayPort connector A DisplayPort port (top right) on a laptop from 2010, near an Ethernet port (center) and a USB port (bottom right). DisplayPort (DP) is a proprietary [a] digital display interface developed by a consortium of PC and chip manufacturers and standardized by the Video Electronics Standards Association (VESA).
A system administrator may adjust the maximum window size limit, or adjust the constant added during additive increase, as part of TCP tuning. The flow of data over a TCP connection is also controlled by the use of the receive window advertised by the receiver. A sender can send data less than its own congestion window and the receive window.
A common use of Thiele/Small parameters is in designing PA system and hi-fi speaker enclosures; the TSP calculations indicate to the speaker design professionals how large a speaker cabinet will need to be and how large and long the bass reflex port (if it is used) should be.
This band pass filter is designed to cover the 2.5-2.6 GHz and 3.4-3.7 GHz spectrum for the 4G and 5G wireless communication applications respectively. It is developed and extended from 3-pole single-band band pass filter, where an additional resonator is applied to a 3-pole single-band band pass filter.
If the system can be taken offline, the best tuning method often involves subjecting the system to a step change in input, measuring the output as a function of time, and using this response to determine the control parameters. [citation needed]