enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Reel-to-reel audio tape recording - Wikipedia

   en.wikipedia.org/wiki/Reel-to-reel_audio_tape...

   To prepare for use, the supply reel (or feed reel) containing the tape is placed on a spindle or hub. The end of the tape is manually pulled from the reel, threaded through mechanical guides and over a tape head assembly, and attached by friction to the hub of the second, initially empty takeup reel.

3. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The brad point drill bit (also known as lip and spur drill bit, and dowel drill bit) is a variation of the twist drill bit which is optimized for drilling in wood. Conventional twist drill bits tend to wander when presented to a flat workpiece. For metalwork, this is countered by drilling a pilot hole with a spotting drill bit.

4. Wire rope spooling technology - Wikipedia

   en.wikipedia.org/wiki/Wire_rope_spooling_technology

   Alternatively, a sheave can be integrated and installed within the housing frame. In this case, the system can be set up anywhere around the drum. Oceanographic installations that spool rope up to 46 layers have demonstrated that level winders give synchronized and controlled spooling in the harshest, most testing conditions.

5. Fishing reel - Wikipedia

   en.wikipedia.org/wiki/Fishing_reel

   Parts of a spinning reel: 1: Pick up or bail 2: Reel seat 3: Reel foot 4: Handle 5: Support arm 6: Anti-reverse lever 7: Skirted spool 8: Fishing line 9: Drag adjustment knob A fishing reel is a hand- cranked reel used in angling to wind and stow fishing line , [ 1 ] typically mounted onto a fishing rod , but may also be used on compound bows ...

6. Spooling - Wikipedia

   en.wikipedia.org/wiki/Spooling

   Nowadays, the most common use of spooling is printing: documents formatted for printing are stored in a queue at the speed of the computer, then retrieved and printed at the speed of the printer. Multiple processes can write documents to the spool without waiting, and can then perform other tasks, while the "spooler" process operates the ...

7. Tripping (pipe) - Wikipedia

   en.wikipedia.org/wiki/Tripping_(pipe)

   Vertical Drill Bit. Drill bits wear and tear like most any other piece of equipment. Once a bit becomes too worn to drill at an adequate rate or make a full-gauge hole, or if the bearings are thought to be near failure, a trip is undertaken to replace the bit. A trip is not considered a bit trip when the purpose of replacing the bit is to ...

8. Spinner's weasel - Wikipedia

   en.wikipedia.org/wiki/Spinner's_weasel

   Spinner's weasel or clock reel is a mechanical yarn-measuring device consisting of a spoked wheel with gears attached to a pointer on a marked face (which resembles a clock) and an internal mechanism that makes a "pop" sound after the desired length of yarn is measured (usually a skein). The pointer allows the spinner to see how close they are ...

9. Speeds and feeds - Wikipedia

   en.wikipedia.org/wiki/Speeds_and_feeds

   Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.