enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Roof pitch - Wikipedia

   en.wikipedia.org/wiki/Roof_pitch

   Historically, roof pitch was designated in two other ways: A ratio of the ridge height to the width of the building (span) [6] and as a ratio of the rafter length to the width of the building. [7] Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°);

3. List of unusual units of measurement - Wikipedia

   en.wikipedia.org/wiki/List_of_unusual_units_of...

   A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...

4. Square (unit) - Wikipedia

   en.wikipedia.org/wiki/Square_(unit)

   The square is an Imperial unit of area that is used in the construction industry in the United States and Canada, [1] and was historically used in Australia. One square is equal to 100 square feet. Examples where the unit is used are roofing shingles, metal roofing, vinyl siding, and fibercement siding products.

5. Domestic roof construction - Wikipedia

   en.wikipedia.org/wiki/Domestic_roof_construction

   Section view through a house roof drawing showing names for parts of the structure. [clarification needed] (UK and Australia). Ctrs. means centers, a typical line to which carpenters layout framing. Domestic roof construction is the framing and roof covering which is found on most detached houses in cold and temperate climates. [1]

6. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

7. Surface roughness - Wikipedia

   en.wikipedia.org/wiki/Surface_roughness

   Areal roughness parameters are defined in the ISO 25178 series. The resulting values are Sa, Sq, Sz,... Many optical measurement instruments are able to measure the surface roughness over an area. Area measurements are also possible with contact measurement systems. Multiple, closely spaced 2D scans are taken of the target area.