Search results
Results from the WOW.Com Content Network
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
VLAN Trunking Protocol (VTP) is a Cisco proprietary protocol that propagates the definition of VLANs on the whole local area network. VTP is available on most of the Cisco Catalyst Family products. The comparable IEEE standard in use by other manufacturers is GARP VLAN Registration Protocol (GVRP) or the more recent Multiple VLAN Registration ...
A VLAN Management Policy Server (VMPS) is a network switch that contains a mapping of device information to VLAN.. The primary goal of VMPS is VLAN assignment for general network management purposes, but can also be used for providing security through segregating clients with an unknown MAC address, or through further extension of the protocol to provide login for Cisco ACLs.
Protocol Number Keyword Protocol References/RFC; 0x00 0 HOPOPT IPv6 Hop-by-Hop Option: RFC 8200: 0x01 1 ICMP Internet Control Message Protocol: RFC 792: 0x02 2 IGMP Internet Group Management Protocol: RFC 1112: 0x03 3 GGP Gateway-to-Gateway Protocol: RFC 823: 0x04 4 IP-in-IP IP in IP (encapsulation) RFC 2003: 0x05 5 ST Internet Stream Protocol ...
In such cases, it is possible to limit the BUM traffic for specific ports in order to have a control on the number of packets or bytes that are flooded on the VLAN to other devices. This threshold is represented in kilobits per second (kbps), and it can be set for broadcast rate, multicast rate and unknown unicast rate independently.
To do this, VTP carries VLAN information to all the switches in a VTP domain. VTP advertisements can be sent over 802.1Q, and ISL trunks. VTP is available on most of the Cisco Catalyst Family products. Using VTP, each Catalyst Family Switch advertises the following on its trunk ports: Management domain; Configuration revision number
A VLAN access control list (VACL) provides access control for all packets that are bridged within a VLAN or that are routed into or out of a VLAN. Unlike regular Cisco IOS access control lists that are configured on router interfaces and applied on routed packets only, VACLs apply to all packets.
Within a layer 2 network, MVRP provides a method to dynamically share VLAN information and configure the needed VLANs. For example, in order to add a switch port to a VLAN, only the end port, or the VLAN-supporting network device connected to the switch port need be reconfigured, and all necessary VLAN trunks are dynamically created on the ...