enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Alveolar gas equation - Wikipedia

   en.wikipedia.org/wiki/Alveolar_gas_equation

   The alveolar gas equation is the method for calculating partial pressure of alveolar oxygen ( pAO2 ). The equation is used in assessing if the lungs are properly transferring oxygen into the blood. The alveolar air equation is not widely used in clinical medicine, probably because of the complicated appearance of its classic forms.

3. Schwarzschild's equation for radiative transfer - Wikipedia

   en.wikipedia.org/wiki/Schwarzschild's_equation...

   In the study of heat transfer, Schwarzschild's equation[ 1][ 2][ 3] is used to calculate radiative transfer ( energy transfer via electromagnetic radiation) through a medium in local thermodynamic equilibrium that both absorbs and emits radiation. The incremental change in spectral intensity, [ 4] ( dIλ, [W/sr/m 2 /μm]) at a given wavelength ...

4. Darcy–Weisbach equation - Wikipedia

   en.wikipedia.org/wiki/Darcy–Weisbach_equation

   The equation is named after Henry Darcy and Julius Weisbach. Currently, there is no formula more accurate or universally applicable than the Darcy-Weisbach supplemented by the Moody diagram or Colebrook equation. [1] The Darcy–Weisbach equation contains a dimensionless friction factor, known as the Darcy friction factor. This is also ...

5. Fractional excretion of sodium - Wikipedia

   en.wikipedia.org/wiki/Fractional_excretion_of_sodium

   This is the numerator in the equation. The denominator is the total amount of sodium filtered by the kidneys. This is calculated by multiplying the plasma sodium concentration by the glomerular filtration rate (GFR) calculated using creatinine filtration. The flow rates then cancel out, simplifying to the standard equation: [1]

6. Carothers equation - Wikipedia

   en.wikipedia.org/wiki/Carothers_equation

   The simplest case refers to the formation of a strictly linear polymer by the reaction (usually by condensation) of two monomers in equimolar quantities. An example is the synthesis of nylon-6,6 whose formula is [−NH−(CH 2) 6 −NH−CO−(CH 2) 4 −CO−] n from one mole of hexamethylenediamine, H 2 N(CH 2) 6 NH 2, and one mole of adipic acid, HOOC−(CH 2) 4 −COOH.

7. Logarithmic decrement - Wikipedia

   en.wikipedia.org/wiki/Logarithmic_decrement

   The logarithmic decrement can be obtained e.g. as ln(x 1 /x 3).Logarithmic decrement, , is used to find the damping ratio of an underdamped system in the time domain.. The method of logarithmic decrement becomes less and less precise as the damping ratio increases past about 0.5; it does not apply at all for a damping ratio greater than 1.0 because the system is overdamped.

8. Radiative forcing - Wikipedia

   en.wikipedia.org/wiki/Radiative_forcing

   Radiative forcing is defined in the IPCC Sixth Assessment Report as follows: "The change in the net, downward minus upward, radiative flux (expressed in W/m 2) due to a change in an external driver of climate change, such as a change in the concentration of carbon dioxide (CO 2), the concentration of volcanic aerosols or the output of the Sun." [3]: 2245

9. Per-unit system - Wikipedia

   en.wikipedia.org/wiki/Per-unit_system

   In the power systems analysis field of electrical engineering, a per-unit system is the expression of system quantities as fractions of a defined base unit quantity. Calculations are simplified because quantities expressed as per-unit do not change when they are referred from one side of a transformer to the other.