enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. SMC Corporation - Wikipedia

   en.wikipedia.org/wiki/SMC_Corporation

   SMC develops a broad range of control systems and equipment, such as directional control valves, actuators, and air line equipment, to support diverse applications. SMC's head office is located in Sotokanda, Chiyoda-ku, Tokyo, Japan.

3. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   Air cored Microwave connectors The name of a connector (e.g. 1.85) is determined by the diameter in mm of the air dielectric around the centre pin 3.5 and 2.92 mm (sometimes called K) connectors, which also have a 0.9mm centre pin and cross-mate with SMA and offer higher maximum frequency

4. SMC connector - Wikipedia

   en.wikipedia.org/wiki/SMC_connector

   Some extended performance versions are rated to 10 GHz. The normally free part (a.k.a. plug) of a SMC connector that has a socket for the centre contact are the female connectors. The normally fixed part (a.k.a. jack) SMC connectors that has a pin for the centre contact are the male connectors. This is the reverse of most RF connectors.

5. Air-line fitting - Wikipedia

   en.wikipedia.org/wiki/Air-line_fitting

   Nipples with mating safety couplings. Also known as pneumatic couplings, quick disconnects, air couplers, quick connect couplers, and quick couplers, hand-operable air-line fittings allow manual disconnection of gas supply lines, including compressed air and breathable air (a subset of breathing gases).

6. N connector - Wikipedia

   en.wikipedia.org/wiki/N_connector

   The male connector is hand-tightened (though versions with a hex nut are also available) and has an air gap between the center and outer conductors. The coupling has a 5 ⁄ 8 -24 UNEF thread . Amphenol suggests tightening to a torque of 15 inch-pounds (1.7 N⋅m), [ 2 ] while Andrew Corporation suggest 20 inch-pounds (2.3 N⋅m) for their hex ...

7. Push-to-pull compression fittings - Wikipedia

   en.wikipedia.org/wiki/Push-to-pull_compression...

   A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).