Search results
Results from the WOW.Com Content Network
Message Signaled Interrupts (MSI) are a method of signaling interrupts, using special in-band messages to replace traditional out-of-band signals on dedicated interrupt lines. While message signaled interrupts are more complex to implement in a device, they have some significant advantages over pin-based out-of-band interrupt signalling, such ...
SMM is a special-purpose operating mode provided for handling system-wide functions like power management, system hardware control, or proprietary OEM designed code. It is intended for use only by system firmware (BIOS or UEFI), not by applications software or general-purpose systems software. The main benefit of SMM is that it offers a ...
Every signaling system can be characterized along each of the above axes of classification. A few examples: DTMF is an in-band, channel-associated register signaling system. It is not compelled. SS7 (e.g., TUP or ISUP) is an out-of-band, common-channel signaling system that incorporates both line and register signaling.
PBS—Portable Batch System; PC—Personal Computer; PCB—Printed Circuit Board; PCB—Process Control Block; PC DOS—Personal Computer Disc Operating System; PCI—Peripheral Component Interconnect; PCIe—PCI Express; PCI-X—PCI Extended; PCL—Printer Command Language; PCMCIA—Personal Computer Memory Card International Association; PCM ...
In a computer, an interrupt request (or IRQ) is a hardware signal sent to the processor that temporarily stops a running program and allows a special program, an interrupt handler, to run instead. Hardware interrupts are used to handle events such as receiving data from a modem or network card, key presses, or mouse movements.
The link operates in either low power (LP) mode or high speed (HS) mode. In low power mode, the high-speed clock is disabled, and signal clocking information is embedded in the data. In this mode, the data rate is insufficient to drive a display, but is usable for sending configuration information and commands.
These errors include non-recoverable internal system chipset errors, corruption in system memory such as parity and ECC errors, and data corruption detected on system and peripheral buses. On some systems, a computer user can trigger an NMI through hardware and software debugging interfaces and system reset buttons.
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...