Search results
Results from the WOW.Com Content Network
CDP was created by Cisco in 1994. [2] Its original intent was to make it easier to find other devices on a network. [1] CDP may be used between Cisco routers, switches and other network equipment to advertise their software version, capabilities and IP address. [3] The two versions of CDP are CDPv1 and CDPv2:
On-Demand Routing ("ODR") is an enhancement to Cisco Discovery Protocol (CDP), a protocol used to discover other Cisco devices on either broadcast or non-broadcast media. With the help of CDP, it is possible to find the device type, the IP address, the Cisco IOS version running on the neighbor Cisco device, the capabilities of the neighbor device, and so on.
Cisco Discovery Protocol (CDP) is a proprietary data link layer protocol developed by Cisco Systems in 1994 [1] by Keith McCloghrie and Dino Farinacci. It is used to share information about other directly connected Cisco equipment, such as the operating system version and IP address .
Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private network Used for local communications within a private network [3] 192.0.0.0/24 192.0.0.0–192.0.0.255 256
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
Address of the server: 192.168.1.2; Address of a local computer: 192.168.1.100; If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet ...
The Secure Neighbor Discovery (SEND) protocol is a security extension of the Neighbor Discovery Protocol (NDP) in IPv6 defined in RFC 3971 and updated by RFC 6494.. The Neighbor Discovery Protocol (NDP) is responsible in IPv6 for discovery of other network nodes on the local link, to determine the link layer addresses of other nodes, and to find available routers, and maintain reachability ...
Neighbor Table: The neighbor table keeps a record of the IP addresses of routers that have a direct physical connection with this router. Routers that are connected to this router indirectly, through another router, are not recorded in this table as they are not considered neighbors.