Search results
Results from the WOW.Com Content Network
c.o.c. = actual double recombinant frequency / expected double recombinant frequency. Interference is then defined as follows: [1] interference = 1 − c.o.c. This figure tells us how strongly a crossover in one of the DNA regions (AB or BC) interferes with the formation of a crossover in the other region.
The cutoff frequency is the critical frequency between propagation and attenuation, which corresponds to the frequency at which the longitudinal wavenumber is zero. It is given by ω c = c ( n π a ) 2 + ( m π b ) 2 {\displaystyle \omega _{c}=c{\sqrt {\left({\frac {n\pi }{a}}\right)^{2}+\left({\frac {m\pi }{b}}\right)^{2}}}} The wave equations ...
Where d is the distance in map units, the Morgan Mapping Function states that the recombination frequency r can be expressed as =.This assumes that one crossover occurs, at most, in an interval between two loci, and that the probability of the occurrence of this crossover is proportional to the map length of the interval.
A passive crossover circuit is often mounted in a speaker enclosure to split up the amplified signal into a lower-frequency signal range and a higher-frequency signal range. A passive crossover splits up an audio signal after it is amplified by a single power amplifier , so that the amplified signal can be sent to two or more driver types, each ...
A typical characteristic of a 2-way speaker is that at the crossover frequency, due to the physical distance between the centres of the woofer and tweeter, the sound that emanates from the combination is not omni-directional, but lobed. Within the region of the lobe the sound level, at the crossover frequency is much higher as compared to ...
In genetics, the crossover value is the linked frequency of chromosomal crossover between two gene loci ().For a fixed set of genetic and environmental conditions, recombination in a particular region of a linkage structure tends to be constant and the same is then true for the crossover value which is used in the production of genetic maps.
A consequence of this method of counter-propagating beams on a system with more than two states is the presence of crossover lines. When two transitions are within a single Doppler-broadened feature and share a common ground state, a crossover peak at a frequency exactly between the two transitions can occur.
Crossover interference is the term used to refer to the non-random placement of crossovers with respect to each other during meiosis.The term is attributed to Hermann Joseph Muller, who observed that one crossover "interferes with the coincident occurrence of another crossing over in the same pair of chromosomes, and I have accordingly termed this phenomenon ‘interference’."