Search results
Results from the WOW.Com Content Network
The siemens (symbol: S) is the unit of electric conductance, electric susceptance, and electric admittance in the International System of Units (SI). Conductance, susceptance, and admittance are the reciprocals of resistance, reactance, and impedance respectively; hence one siemens is equal to the reciprocal of one ohm (Ω −1) and is also referred to as the mho.
The conversion of conductivity (in μS/cm) to the total dissolved solids (in mg/kg) depends on the chemical composition of the sample and can vary between 0.54 and 0.96. Typically, the conversion is done assuming that the solid is sodium chloride; 1 μS/cm is then equivalent to about 0.64 mg of NaCl per kg of water.
where is the length of the conductor, measured in metres (m), A is the cross-sectional area of the conductor measured in square metres (m 2), σ is the electrical conductivity measured in siemens per meter (S·m −1), and ρ is the electrical resistivity (also called specific electrical resistance) of the material, measured in ohm-metres (Ω ...
The SI unit of electrical resistivity is the ohm-metre (Ω⋅m). [1] [2] [3] For example, if a 1 m 3 solid cube of material has sheet contacts on two opposite faces, and the resistance between these contacts is 1 Ω, then the resistivity of the material is 1 Ω⋅m.
The convert template has 1 square mile = 2,589,988.110336 square meters. ... 1/60: mole per minute: moles per minute: mol/s: ... inch per hour: inches per hour: cm/h ...
0.17 minutes 10 2: hectosecond: 100: 1.67 minutes (or 1 minute 40 seconds) 10 3: kilosecond: 1 000: 16.7 minutes (or 16 minutes and 40 seconds) 10 6: megasecond: 1 000 000: 11.6 days (or 11 days, 13 hours, 46 minutes and 40 seconds) 10 9: gigasecond: 1 000 000 000: 31.7 years (or 31 years, 252 days, 1 hour, 46 minutes, 40 seconds, assuming that ...
Admittance Y, measured in siemens, is defined as the inverse of impedance Z, measured in ohms: Y ≡ 1 Z {\displaystyle Y\equiv {\frac {1}{Z}}} Resistance is a measure of the opposition of a circuit to the flow of a steady current, while impedance takes into account not only the resistance but also dynamic effects (known as reactance ).
For example, 10 miles per hour can be converted to metres per second by using a sequence of conversion factors as shown below: = . Each conversion factor is chosen based on the relationship between one of the original units and one of the desired units (or some intermediary unit), before being rearranged to create a factor that cancels out the ...