Search results
Results from the WOW.Com Content Network
Message Signaled Interrupts (MSI) are a method of signaling interrupts, using special in-band messages to replace traditional out-of-band signals on dedicated interrupt lines. While message signaled interrupts are more complex to implement in a device, they have some significant advantages over pin-based out-of-band interrupt signalling, such ...
The link operates in either low power (LP) mode or high speed (HS) mode. In low power mode, the high-speed clock is disabled, and signal clocking information is embedded in the data. In this mode, the data rate is insufficient to drive a display, but is usable for sending configuration information and commands.
Sending data from sub to main may use the opposite clock edge as main to sub. Devices often require extra clock idle time before the first clock or after the last one, or between a command and its response. Some devices have two clocks, one to read data, and another to transmit it into the device. Many of the read clocks run from the chip ...
The Message Signaled Interrupts (MSI) feature of the PCI 2.2 and later specifications cannot be used without the local APIC being enabled. [8] Use of MSI obviates the need for an I/O APIC. Additionally, up to 224 interrupts are supported in MSI mode, and IRQ sharing is not allowed. [9]
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
The serial ports are frequently disabled to free an IRQ line for another device. IRQ 2/9 is the traditional interrupt line for an MPU-401 MIDI port, but this conflicts with the ACPI system control interrupt (SCI is hardwired to IRQ9 on Intel chipsets); [6] this means ISA MPU-401 cards with a hardwired IRQ 2/9, and MPU-401 device drivers with a ...
1.5 — all of 1.4 plus specification corrections and clarifications to absolute volume control, browsing and other features [9] 1.6 — all of 1.5 plus browsing data and track information [10] Number of items that are in a folder without downloading the list; Support for transmitting cover arts through the BIP over OBEX protocol.
Reset USB device to a known initial state. SE0 ≥ 2.5 ms Suspend Power down the device, such that it would only consume 0.5 mA from V BUS. Exits this state only after a resume or reset signal is received. To avoid this state a SOF packet (high speed) or a keep alive (low speed) signal is given. J ≥ 3 ms Resume (host)