Search results
Results from the WOW.Com Content Network
A simple SCR circuit with a resistive load. A simple SCR circuit can be illustrated using an AC voltage source connected to a SCR with a resistive load. Without an applied current pulse to the gate of the SCR, the SCR is left in its forward blocking state. This makes the start of conduction of the SCR controllable.
In a synchronous generator, [1] the short circuit ratio is the ratio of field current required to produce rated armature voltage at the open circuit to the field current required to produce the rated armature current at short circuit. [1] [2] This ratio can also be expressed as an inverse of the saturated [3] direct-axis synchronous reactance ...
Large penetration of the inverter-based resources (IBRs) reduces the short circuit level: a typical synchronous generator can deliver a significant overcurrent, 2-5 [7] p.u., for a relatively long time (minutes), while the component limitations of the IBRs result in overcurrent limits of less than 2 [7] p.u. (usually 1.1-1.2 p.u.). [4] The ...
Topology of blocking mode cycloconverter [1]. A cycloconverter (CCV) or a cycloinverter converts a constant amplitude, constant frequency AC waveform to another AC waveform of a lower frequency by synthesizing the output waveform from segments of the AC supply without an intermediate DC link (Dorf 1993, pp. 2241–2243 and Lander 1993, p. 181).
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
Figure 2.1. Circuit diagram of a ladder network low-pass filter: a two-element-kind network. Comprehensive cataloguing of network graphs as they apply to electrical circuits began with Percy MacMahon in 1891 (with an engineer-friendly article in The Electrician in 1892) who limited his survey to series and parallel combinations. MacMahon called ...
Comparison of an SCR and GTO of same rating Characteristic Description Thyristor (1600 V, 350 A) GTO (1600 V, 350 A) V T on: On-state voltage drop 1.5 V 3.4 V t on, I g on: Turn-on time, gate current 8 μs, 200 mA 2 μs, 2 A t off: Turn-off time 150 μs 15 μs
Main Terminal 1 (MT1) and Main Terminal 2 (MT2) are also referred to as Anode 1 (A1) and Anode 2 (A2) respectively. [2] The relative sensitivity depends on the physical structure of a particular triac, but as a rule, quadrant I is the most sensitive (least gate current required), and quadrant 4 is the least sensitive (most gate current required).