Search results
Results from the WOW.Com Content Network
A compound crown molding built up out of several individual trim elements Decorative pilaster of natural cherry hardwood topped with crown molding Crown molding may be a complex build-up of multiple trim elements, in this case built-out slightly above a window with short 90-degree returns The relief on this short 90-degree return of crown molding was back-cut with a coping saw
Consider the fabrication of a hollow plastic box, without lid. Once the plastic has hardened around the mold, the mold must be removed. As the plastic hardens, it may contract slightly. By tapering the sides of the mold by an appropriate "draft angle", for instance 2° (two degrees), the mold will be easier to remove.
The trim and rafters at this edge are called rakes, rake board, rake fascia, verge-boards, barge-boards or verge-or barge-rafters. [3] It is a sloped timber on the outside facing edge of a roof running between the ridge and the eave. [4] On a typical house, any gable will have two rakes, one on each sloped side.
Credit cards. Credit cards can work fine for smaller improvements, but watch out for high interest rates. Consider using a 0% intro APR credit card to pay for expenses so you can make the most of ...
Ovolo: Simple, convex quarter-round moulding that can also be enriched with the egg-and-dart or other pattern; Neck moulding; Panel mould: A moulding that is flat on the back and profiled on the face. It is applied directly on a flat surface like a wall or flush door in squares or rectangles to simulate a panel.
Interior elevations are used to show details such as millwork and trim configurations. In the building industry elevations are non-perspective views of the structure. These are drawn to scale so that measurements can be taken for any aspect necessary. Drawing sets include front, rear, and both side elevations.
A building's surface detailing, inside and outside, often includes decorative moulding, and these often contain ogee-shaped profiles—consisting (from low to high) of a concave arc flowing into a convex arc, with vertical ends; if the lower curve is convex and higher one concave, this is known as a Roman ogee, although frequently the terms are used interchangeably and for a variety of other ...
This moulding can be terminated at the side by ornamentation called a label stop. The hood mould was introduced into architecture in the Romanesque period, though they became much more common in the Gothic period. Later, with the increase in rectangular windows they became more prevalent in domestic architecture.