Search results
Results from the WOW.Com Content Network
A mobile data pack refers to an add-on which can enable you to boost the amount of data which you can use on your mobile phone. The rate at which you use your data can also be monitored, so you know how much data you have left. Mobile data is a service which provides a similar service to Wi-Fi and allows you to connect to the Internet.
This additional data includes a sequence number that is used to detect packets that are lost or arrive out of order, and a checksum that allows the errors within packet data to be detected. When either problem occurs, TCP uses automatic repeat request (ARQ) to ask the sender to re-send the lost or damaged packet.
Connection-oriented transport-layer protocols provide connection-oriented communications over connectionless communication systems. A connection-oriented transport layer protocol, such as TCP, may be based on a connectionless network-layer protocol such as IP, but still achieves in-order delivery of a byte-stream by means of segment sequence numbering on the sender side, packet buffering, and ...
In these particular applications, loss of packets is not usually a fatal problem. In VoIP, for example, latency and jitter are the primary concerns. The use of TCP would cause jitter if any packets were lost as TCP does not provide subsequent data to the application while it is requesting a re-send of the missing data.
Connectionless communication, often referred to as CL-mode communication, [1] is a data transmission method used in packet switching networks, using data packets that are frequently called datagrams, in which each data packet is individually addressed and routed based on information carried in each packet, rather than in the setup information of a prearranged, fixed data channel as in ...
Each packet is seen as a set of elements from a Galois field. Therefore, multiplying and adding two packets means multiplying each of its symbols by a coding coefficient chosen from the Galois field and then adding the two packets together, symbol-wise. In the figure, we can see an example of two packets linearly combined into a new coded packet.
Packet-based systems are based on the idea of sending a batch of data, the packet, along with additional data that allows the receiver to ensure it was received correctly, perhaps a checksum. The paradigm is similar to a window sliding sideways to allow entry of fresh packets and reject the ones that have already been acknowledged.
if the ESC byte occurs in the data, the two byte sequence ESC, ESC_ESC is sent. variants of the protocol may begin, as well as end, packets with END. SLIP requires a serial port configuration of 8 data bits, no parity, and either EIA hardware flow control, or CLOCAL mode (3-wire null-modem) UART operation settings.