Ads
related to: hei clear distributor cap for ford 289
Search results
Results from the WOW.Com Content Network
High energy ignition, also known as H.E.I., is an electronic ignition system designed by the Delco-Remy Division of General Motors.It was used on all GM vehicles, at least in the North American market, from 1975 through the mid-1980s.
Duraspark II distributor, cap and HT (high tension) wires. The Duraspark II is a Ford electronic ignition system. Ford Motor Company began using electronic ignitions in 1973 with the Duraspark electronic ignition system and introduced the Duraspark II system in 1976. The biggest change, apart from the control box redesign, was the large ...
A 289 Ford small-block V8 in a 1965 Ford Mustang. The 289 cu in (4.7 L) V8 was introduced in April 1963, carrying the Challenger name over from the 260 [3] and replacing it as the base V8 for full-sized Fords. Bore was expanded to 4.00 in (101.6 mm), becoming the standard for most small block Ford engines. Stroke remained at 2.87 inches.
A distributor consists of a rotating arm ('rotor') that is attached to the top of a rotating 'distributor shaft'. The rotor constantly receives high-voltage electricity from an ignition coil via brushes at the centre of the rotor. As the rotor spins, its tip passes close to (but does not touch) the output contacts for each cylinder.
The Ford 427 block was closer dimensionally to the smaller 392 cu. in. first generation Chrysler FirePower Hemi; the Ford FE's bore spacing was 4.63 in (117.6 mm) compared to the Chrysler 392's 4.5625 in (115.9 mm). The Ford FE's deck height of 10.17 in (258.3 mm) was lower than that of the Chrysler 392 at 10.87 in (276.1 mm).
AOL latest headlines, entertainment, sports, articles for business, health and world news.
The coil-in-cap HEI distributor was retired, and an all-new electronic distributor design was used. The intake manifold to head bolt pattern was redesigned to improve gasket integrity—four of the center intake manifold bolts were drilled at 72° instead of 90° for the cast iron cylinder heads. Changes to the valve covers were also made.
The first Y-block on Ford automobiles and F100 trucks was the 239 cu in (3,910 cc) version as released in 1954 with EBU casting numbers. The Y-block was the same displacement as the old Ford Flathead V8 that it replaced but with a bigger bore and a shorter stroke (3.5 x 3.1 in).
Ads
related to: hei clear distributor cap for ford 289