Search results
Results from the WOW.Com Content Network
A reinforced concrete column is a structural member designed to carry compressive loads, composed of concrete with an embedded steel frame to provide reinforcement. For design purposes, the columns are separated into two categories: short columns and slender columns.
In Australia, these steel sections are commonly referred to as Universal Beams (UB) or Columns (UC). The designation for each is given as the approximate height of the beam, the type (beam or column) and then the unit metre rate (e.g., a 460UB67.1 is an approximately 460 mm (18.1 in) deep universal beam that weighs 67.1 kg/m (135 lb/yd)). [6]
The slenderness ratio is an indicator of the specimen's resistance to bending and buckling, due to its length and cross section. If the slenderness ratio is less than the critical slenderness ratio, the column is considered to be a short column. In these cases, the Johnson parabola is more applicable than the Euler formula. [5]
The cross-section of the column is uniform throughout its length. The direct stress is very small as compared to the bending stress (the material is compressed only within the elastic range of strains). The length of the column is very large as compared to the cross-sectional dimensions of the column. The column fails only by buckling.
The steel shell of a Lally column is filled with concrete, which carries a share of the compression load, and helps prevent local buckling of the shell. The advantage of a Lally column over a conventional structural steel is that it can be cut it to length on a construction site with simple hand tools such as a plumber's pipe cutter or a ...
The steel columns will be connected to the slab by bolting and/or welding them to steel studs extruding from the surface of the poured concrete slab. Pre-cast concrete beams may be delivered on site to be installed for the second floor, after which a concrete slab may be poured for the pavement area.
The name "1-2-3" stemmed from the product's integration of three main capabilities: along with its core spreadsheet functionality, 1-2-3 also offered integral charting/graphing and rudimentary database operations. Data features included sorting data in any defined rectangle, by order of information in one or two columns in the rectangular area.
Steel column members must be verified as adequate to prevent buckling after axial and moment requirements are met. There are currently two common methods of steel design: The first method is the Allowable Strength Design (ASD) method. The second is the Load and Resistance Factor Design (LRFD) method. Both use a strength, or ultimate level ...