enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Dado set - Wikipedia

   en.wikipedia.org/wiki/Dado_set

   Top left: disassembled stacked dado set showing blades and chippers; bottom left: stacked dado set in table saw; right: wobble dado. A dado set or dado blade is a type of circular saw blade, typically used with a table saw or radial arm saw, which is used to cut dadoes or grooves in woodworking. [1] There are two common kinds of dado sets ...

3. Table saw - Wikipedia

   en.wikipedia.org/wiki/Table_saw

   American cabinet saws are normally designed to accept a 13 ⁄ 16-inch-wide (21 mm) stacked dado blade in addition to a standard saw blade. The most common size of blade is 10 inches (250 mm) in diameter with a blade arbor diameter of 5 ⁄ 8 inch (16 mm), but 12 or 14 inches (300 or 360 mm) in diameter with a blade arbor diameter of 1 inch (25 ...

4. Shurly & Dietrich - Wikipedia

   en.wikipedia.org/wiki/Shurly_&_Dietrich

   They hired nine saw makers from Rochester, New York and Sheffield, England and began to manufacture saws in Galt, Ontario, now called Cambridge. [1] [5] By 1886 the company employed 70 skilled workman. [6] The company held a number of Canadian patents for saw design. [7] By 1906, Cosmos' son Theodore Shurly was the factory superintendent. [8]

5. Saw - Wikipedia

   en.wikipedia.org/wiki/Saw

   A circular saw blade with many small teeth, designed for cutting plywood with minimal splintering. Dado blade A special type of circular saw blade used for making wide-grooved cuts in wood so that the edge of another piece of wood will fit into the groove to make a joint. Some dado blades can be adjusted to make different-width grooves.

6. Riving knife - Wikipedia

   en.wikipedia.org/wiki/Riving_knife

   A splitter is a stationary blade of similar thickness to the rotating saw blade mounted behind it to prevent a board from pinching inward into the saw kerf and binding on the saw blade, potentially causing a dangerous kickback. [7] Like a riving knife, its thickness should be greater than the body of the saw blade but thinner than its kerf. [7]

7. Radial arm saw - Wikipedia

   en.wikipedia.org/wiki/Radial_arm_saw

   A saw which combines the sliding and compound features is known as a sliding compound miter saw or SCMS. Before the advent of the radial arm saw, table saws and hand saws were most commonly used for crosscutting lumber. Table saws can easily rip stock, but it is awkward to push a long piece of stock widthwise through a table saw blade.