Search results
Results from the WOW.Com Content Network
Water damage restoration is often prefaced by a loss assessment and evaluation of affected materials. The damaged area is inspected with water sensing equipment such as probes and other infrared tools in order to determine the source of the damage and possible extent of areas affected. Emergency mitigation services are the first order of business.
Double trapping is prohibited by plumbing codes due to its susceptibility to clogging. In the U.S., every plumbing fixture must also be coupled to the system's vent piping. [1] Without a vent, negative pressure can slow the flow of water leaving the system, resulting in clogs, or cause siphonage to empty a trap. The high point of the vent ...
Plumbosolvency is the ability of a solvent, notably water, to dissolve lead.In the public supply of water this is an undesirable property. In (usually older) consumers' premises plumbosolvent water can attack lead pipes, lead service lines, and any lead in solder used to join copper.
Internal pipes can be seen entering the external pipes in the bottom of the cabinet. In case of an internal leak, water will overflow through the external piping and can be detected inside the cabinet. A pipe-in-pipe system [1] is a form of plumbing where all water pipes are running inside another pipe. Its purpose is to ensure that any leaks ...
The drainage system collects any water entering the basement and drains it to an internally placed sump pump system, which will then pump the water out of the basement. The Federal Emergency Management Agency (FEMA) recommends basement waterproofing with a water alarm and "battery-operated backup pump" as a preventive measure against the high ...
IAPMO Standards are the plumbing and mechanical standards of the International Association of Plumbing and Mechanical Officials ().For more than thirty years, IAPMO’s standards-developing efforts have primarily focused on plumbing product standards.
A water detector is an electronic device that is designed to detect the presence of water for purposes such as to provide an alert in time to allow the prevention of water leakage. A common design is a small cable or device that lies flat on a floor and relies on the electrical conductivity of
In plumbing, a trap is a U-shaped portion of pipe designed to trap liquid or gas to prevent unwanted flow; most notably sewer gases from entering buildings while allowing waste materials to pass through. In oil refineries, traps are used to prevent hydrocarbons and other dangerous gases and chemical fumes from escaping through drains.