Search results
Results from the WOW.Com Content Network
Water enters at right, fills the trap, and continues left. Inverted siphoning occurs below the line "A". Examples of traps [further explanation needed] In plumbing, a trap is a U-shaped portion of pipe designed to trap liquid or gas to prevent unwanted flow; most notably sewer gases from entering buildings while allowing waste materials to pass ...
Unlike the kitchen sink–which should be cleaned weekly if not daily says Koch–the drain can be done less often. “Ideally, I'd say to try to clean it once a month,” Koch says.
Grease trap sizing is based on the size of the 2- or 3-compartment sink, dishwasher, pot sinks, and mop sinks. Many manufacturers and vendors offer online sizing tools to make these calculations easy. The cumulative flow rates of these devices, as well as overall grease retention capacity (in pounds or kilograms) are considered.
In shop drawings pipe sizes should be marked with the text and size should be shown with double line. Each pipes with different purposes will be displayed with different colors for ease of understanding. Drainage pipes should be shown with slope. For water supply, pump capacity and number of pumps will be attached as drawing file.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
Pool drain vortex as viewed from above the water at Grange Park wading pool Underwater view of drain, showing vortex-formation phenomenon. A drain is the primary vessel or conduit for unwanted water or waste liquids to flow away, either to a more useful area, funnelled into a receptacle, or run into sewers or stormwater mains as waste discharge to be released or processed.
Steel pipe is often joined with threaded connections; tapered threads are cut into the end of the pipe, and sealant is applied in the form of thread-sealing compound or thread seal tape (also known as PTFE or Teflon tape) and the pipe is screwed into a threaded fitting with a pipe wrench.
In some occasional cases, a sink may have both a potable (drinkable) and a non-potable water supply. Lavatories and water closets normally connect to the water supply by means of a supply , which is a tube, usually of nominal 3/8 in ( United States ) or 10 or 12 mm diameter ( Europe and Middle East ), which connects the water supply to the ...