Search results
Results from the WOW.Com Content Network
The Arduino software includes a serial monitor which allows simple textual data to be sent to and from the Arduino board. The RX and TX LEDs on the board flash when data is being transmitted via the FTDI chip and the USB connection to the computer (but not for serial communication on pins 0 and 1).
Extended Display Identification Data (EDID) and Enhanced EDID (E-EDID) are metadata formats for display devices to describe their capabilities to a video source (e.g., graphics card or set-top box). The data format is defined by a standard published by the Video Electronics Standards Association (VESA).
Based on the same WIZnet W5100 chip as the Arduino Ethernet Shield. [35] A serial interface is provided for programming, but no USB interface. Late versions of this board support Power over Ethernet (PoE). Arduino Fio [36] ATmega328P [27] 8 MHz minimal 66.0 mm × 27.9 mm [ 2.6 in × 1.1 in ] XBee Serial 3.3 V 32 1 2 14 6 8 March 18, 2010 [37]
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.
Arduino (/ ɑː r ˈ d w iː n oʊ /) is an Italian open-source hardware and software company, project, and user community that designs and manufactures single-board microcontrollers and microcontroller kits for building digital devices.
The line on a diagram staying up indicates an excited ("mark" or 1) state of the line, low − unasserted ("space" or 0) state. Both up and low lines drawn for a bit (forming a square) indicate a data bit with value that can be either 0 or 1. The data/parity/stop (D/P/S) conventional notation specifies the framing of a serial connection.
Arduino Software (IDE) includes a serial monitor which allows simple textual data to be sent to and from the board. The RX and TX LEDs on the board will flash when data is being transmitted via the USB-to-serial chip and USB connection to the computer (but not for serial communication on pins 0 and 1).
SDI-12 (Serial Digital Interface at 1200 baud) is an asynchronous serial communications protocol for intelligent sensors that monitor environment data. These instruments are typically low-power (12 volts), are used at remote locations, and usually communicate with a data logger or other data acquisition device.