Search results
Results from the WOW.Com Content Network
Flow table with a grip and a hinge, 70 centimetres (28 in) square. In the American version of this test, the table is 10 inches (25 cm) diameter per ASTM C 230.; Abrams cone, open at the top and at the bottom - 30 centimetres (12 in) high, 17 centimetres (6.7 in) top diameter, 25 centimetres (9.8 in) base diameter.
While the diameter of the hole is not directly measured throughout the test, it can be estimated using the measured flow rate as well as an estimated friction factor. [1] From the change in diameter of the hole over time, the rate of erosion can thus be plotted against applied hydraulic shear stress and fit to the following equation: [1] [4]
The hydraulic diameter, D H, is a commonly used term when handling flow in non-circular tubes and channels. Using this term, one can calculate many things in the same way as for a round tube. When the cross-section is uniform along the tube or channel length, it is defined as [1] [2] =, where
The test uses a thick-walled sampling tube, with an outside diameter of 5.01 cm (2 in) and an inside diameter of 3.5 cm (1.375 in), and a length of at least 60 cm (24 in). The sampling tube is driven into the ground at the bottom of a borehole by blows from a hammer with a mass of 63.5 kg (140 lb) falling a distance of 75 cm (30 in). The sample ...
Note that the dimensionless stress concentration factor is a function of the geometry shape and independent of its size. [4] These factors can be found in typical engineering reference materials. Stress concentration around an elliptical hole in a plate in tension. E. Kirsch derived the equations for the elastic stress distribution around a hole.
The hole diameter might be specified as 10.03 mm with a manufacturing tolerance of ±0.01 mm ("plus-or-minus" 0.01 mm). This means that the smallest acceptable hole diameter will be 10.02 mm while the largest acceptable shaft diameter will be 10.01 mm, leaving an "allowance" of 0.01 mm.
The precast concrete slab has tubular voids extending the full length of the slab, typically with a diameter equal to the 2/3–3/4 the thickness of the slab. This makes the slab much lighter than a massive solid concrete floor slab of equal thickness or strength. The reduced weight also lowers material and transportation costs.
A caliper log is a well logging tool that provides a continuous measurement of the size and shape of a borehole along its depth [1] and is commonly used in hydrocarbon exploration. The measurements that are recorded can be an important indicator of wash-outs, cave ins or shale swelling in the borehole, which can affect the results of other well ...