Search results
Results from the WOW.Com Content Network
A frame is "the unit of transmission in a link layer protocol, and consists of a link layer header followed by a packet." [2] Each frame is separated from the next by an interframe gap. A frame is a series of bits generally composed of frame synchronization bits, the packet payload, and a frame check sequence.
The Layer 4: transport layer PDU is the segment or the datagram. The Layer 3: network layer PDU is the packet. The Layer 2: data link layer PDU is the frame. The Layer 1: physical layer PDU is the bit or, more generally, symbol. Given a context pertaining to a specific OSI layer, PDU is sometimes used as a synonym for its representation at that ...
The internal structure of an Ethernet frame is specified in IEEE 802.3. [2] The table below shows the complete Ethernet packet and the frame inside, as transmitted, for the payload size up to the MTU of 1500 octets. [b] Some implementations of Gigabit Ethernet and other higher-speed variants of Ethernet support larger frames, known as jumbo frames.
The TCP segment is then encapsulated into an Internet Protocol (IP) datagram, and exchanged with peers. [14] The term TCP packet appears in both informal and formal usage, whereas in more precise terminology segment refers to the TCP protocol data unit (PDU), datagram [15] to the IP PDU, and frame to the data link layer PDU:
In the seven-layer OSI model of computer networking, packet strictly refers to a protocol data unit at layer 3, the network layer. [2] A data unit at layer 2, the data link layer, is a frame.
The term datagram is defined as follows: [20] "A self-contained, independent entity of data carrying sufficient information to be routed from the source to the destination computer without reliance on earlier exchanges between this source and destination computer and the transporting network."
In telecommunications, packet switching is a method of grouping data into short messages in fixed format, i.e. packets, that are transmitted over a digital network. Packets are made of a header and a payload .
In data communications networks, packet segmentation is the process of dividing a data packet into smaller units for transmission over the network. Packet segmentation happens at layer four of the OSI model; the transport layer. [1] Segmentation may be required when: The data packet is larger than the maximum transmission unit supported by the ...