Ads
related to: panel mounted fuse holdersautomationdirect.com has been visited by 10K+ users in the past month
octopart.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
Cutouts are typically mounted about 20 degrees off vertical so that the center of gravity of the fuse holder is displaced and the fuse holder will rotate and fall open under its own weight when the fuse blows. Mechanical tension on the fuse link normally holds an ejector spring in a stable position.
D0-type (Neozed) fuses were introduced in 1967 and use the same concept, but have a smaller, cylindrical body. They are available in three different sizes with ratings from 2 A up to 100 A (see table). Fuse holders may be secured by screws to a panel, attached to bus bars, or mounted on DIN rails.
Automotive fuses are used to protect the wiring and electrical equipment for vehicles. There are several different types of automotive fuses and their usage is dependent upon the specific application, voltage, and current demands of the electrical circuit. Automotive fuses can be mounted in fuse blocks, inline fuse holders, or fuse clips.
Automotive fuses are typically housed inside one or more fuse boxes (also called an integrated power module (IPM)) within the vehicle, typically on one side of the engine compartment and/or under the dash near the steering wheel. Some fuses or circuit breakers may nonetheless be placed elsewhere, such as near the cabin fan or air bag controller.
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
Variation of COB, where a chip is mounted directly to a flex circuit. Unlike COB, it may not use wires nor be covered with epoxy, using underfill instead. TAB: Tape-automated bonding: Variation of COF, where a flip chip is mounted directly to a flex circuit without the use of bonding wires. Used by LCD driver ICs. COG: Chip-on-glass
Ads
related to: panel mounted fuse holdersautomationdirect.com has been visited by 10K+ users in the past month
octopart.com has been visited by 100K+ users in the past month