Search results
Results from the WOW.Com Content Network
A typical timber shear wall consists of braced panels in the wall line, constructed using structural plywood sheathing, specific nailing at the edges, and supporting framing. A shear wall is an element of a structurally engineered system that is designed to resist in- plane lateral forces, typically wind and seismic loads.
Especially in stone architecture, fluting distinguishes the column shafts and pilasters visually from plain masonry walls behind. [3] Fluting promotes a play of light on a column which helps the column appear more perfectly round than a smooth column. As a strong vertical element it also has the visual effect of minimizing any horizontal joints ...
The curtain wall itself, however, is not ordinarily required to have a rating. This causes a quandary as compartmentalization (fire protection) is typically based upon closed compartments to avoid fire and smoke migrations beyond each engaged compartment. A curtain wall by its very nature prevents the completion of the compartment (or envelope).
Historically a beam is a squared timber, but may also be made of metal, stone, or a combination of wood and metal [1] such as a flitch beam.Beams primarily carry vertical gravitational forces, but they are also used to carry horizontal loads such as those due to earthquake or wind, or in tension to resist rafter thrust or compression (collar beam).
From a designer's point of view, steel plate walls have become a very attractive alternative to other steel systems, or to replace reinforced concrete elevator cores and shear wall. In comparative studies it has been shown that the overall costs of a building can be reduced significantly when considering the following advantages: [ 5 ]
A load-bearing wall or bearing wall is a wall that is an active structural element of a building — that is, it bears the weight of the elements above said wall, resting upon it by conducting its weight to a foundation structure. [1] The materials most often used to construct load-bearing walls in large buildings are concrete, block, or brick.
the collector (or membrane), used as a shear panel to carry in-plane shear; The drag strut member, used to transfer the load to the shear walls or frames; the chord, used to resist the tension and compression forces that develop in the diaphragm since the collector is usually incapable of handling these loads alone
[4] [5] In the case of free-standing columns, the decorative elements atop the shaft are known as a finial. Modern columns may be constructed out of steel, poured or precast concrete, or brick, left bare or clad in an architectural covering, or veneer. Used to support an arch, an impost, or pier, is the topmost member of a column. The bottom ...