Search results
Results from the WOW.Com Content Network
Protocol-Independent Multicast (PIM) is a family of multicast routing protocols for Internet Protocol (IP) networks that provide one-to-many and many-to-many distribution of data over a LAN, WAN or the Internet. It is termed protocol-independent because PIM does not include its own topology discovery mechanism, but instead uses routing ...
Protocol Independent Multicast (PIM) is then used between the local and remote multicast routers to direct multicast traffic from hosts sending multicasts to hosts that have registered through IGMP to receive them. IGMP operates on the network layer (layer 3), just the same as other network management protocols like ICMP. [1]
IPv6 multicast: [41] The low 32 bits an Ethernet address for IPv6 multicast traffic are the low 32 bits of the multicast IPv6 address used. [40]: §2.3.1 For example, IPv6 multicast traffic using the address ff02::d uses the MAC address 33-33-00-00-00-0D, and traffic to ff05::1:3 goes to the MAC address 33-33-00-01-00-03. 01-0C-CD IEC
IP multicast is a method of sending Internet Protocol (IP) datagrams to a group of interested receivers in a single transmission. It is the IP-specific form of multicast and is used for streaming media and other network applications.
To implement the multicast routing, Internet Group Management Protocol (IGMP) and a multicast routing protocol (Reverse-path forwarding, PIM-SM) for registration subscriber grouping and control traffic are required for multicast transmission. [2] [3] [4] Regarding IP multicast, it is a technique for one-to-many communication over an IP network ...
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header. It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header. Both fields are eight bits wide.
Multicast Source Discovery Protocol (MSDP) is a Protocol Independent Multicast (PIM) family multicast routing protocol defined by Experimental RFC 3618. [1] Despite becoming the IPv4 de facto standard for inter-domain multicast, development of the protocol stopped in 2006 and it was decided by the authors not to proceed with making it a proposed standard. [2]
When a multicast packet enters a router's interface, the router looks up the list of networks that are reachable via that interface (i.e., it checks the paths by which the packet could have arrived). If the router finds a matching routing entry for the source IP address of the multicast packet, the RPF check passes and the packet is forwarded ...