Search results
Results from the WOW.Com Content Network
Presta valves use air pressure to hold the valve closed, then use a small nut to ensure the valve stays sealed in use. Loosening the nut takes time, which is a disadvantage for racing. Leaving the nut loose still allows the valve to seal, but may make it easier to have accidental (or malicious) deflation.
Presta valves (also called Sclaverand valves or French valves) are normally only used on bicycles. The stem has a narrower diameter (nominally 6 mm) than the thinnest (nominally 8 mm) Schrader type, and so the bore of the hole in the rim through which the stem passes can be smaller. Has a locknut that needs to be opened to inflate/deflate. [17 ...
The Dunlop valve has a wider base than a Presta valve, similar enough in size to a Schrader valve to use identically drilled valve holes in rims, [3] but it can be inflated with a Presta valve adapter. [4] The inner mechanism of the valve can be replaced easily, without the need for special tools.
Some pumps have a gauge that shows the pressure of air that is forced into the tire. Once the tire is at the correct pressure, the pump valve can be removed from the tire, and the cap can be replaced on the tire valve. There are two main types of tire valves to which the bicycle tire pump attaches. These are the Presta valve and the Schrader ...
Valve stem or simply valve: port for adding or releasing air from the inner tube. Two types are commonly used: Presta and Schrader. A third type, the Woods/Dunlop valve, can still be found in Europe and Asia. Wheel: as in common usage. Traditionally and most commonly spoked; Wingnut: for attaching wheels before the development of the quick ...
Gate valve, mainly for on–off control, with low pressure drop; Globe valve, good for regulating flow. Uses a cylinder movement over a seat; Knife valve, similar to a gate valve, but usually more compact. Often used for slurries or powders on–off control; Needle valve for accurate flow control; Pinch valve, for slurry flow regulation and ...
The most common final control element in the process control industries is the control valve. The control valve manipulates a flowing fluid, such as gas, steam, water, or chemical compounds, to compensate for the load disturbance and keep the regulated process variable as close as possible to the desired set point. [1]
With traditional fixed valve timing, an engine will have a period of "valve overlap" at the end of the exhaust stroke, when both the intake and exhaust valves are open. The intake valve is opened before the exhaust gases have completely left the cylinder, and their considerable velocity assists in drawing in the fresh charge. Engine designers ...