enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Marking knife - Wikipedia

   en.wikipedia.org/wiki/Marking_knife

   The blades on marking knives are made of tool steel, have either a skewed end or a spear point, and the knife edge is bevelled on either one side of the blade or both sides. [4] On single-bevel skewed knives the side of the blade that is bevelled dictates whether the knife is for left-handed or right-handed use, while single-bevel spear point ...

3. Square (tool) - Wikipedia

   en.wikipedia.org/wiki/Square_(tool)

   The stock is usually thicker than the blade, with the blade being fixed into or onto the stock. The blade typically has parallel edges. The stock is usually held against the edge of a workpiece or drawing board and the tongue is then used as a straight edge for making a mark, or as a reference to check the accuracy of an angle.

4. Straightedge - Wikipedia

   en.wikipedia.org/wiki/Straightedge

   A straightedge or straight edge is a tool used for drawing straight lines, or checking their straightness. If it has equally spaced markings along its length, it is usually called a ruler . Straightedges are used in the automotive service and machining industry to check the flatness of machined mating surfaces.

5. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   A "D-handle" fixed-base router. The router [a] is a power tool with a flat base and a rotating blade extending past the base. The spindle may be driven by an electric motor or by a pneumatic motor. It routs (hollows out) an area in hard material, such as wood or plastic. Routers are used most often in woodworking, especially cabinetry.

6. Try square - Wikipedia

   en.wikipedia.org/wiki/Try_square

   Using a try square to mark lines perpendicular to the edge. Using a try square to check if the full length of a board is square. The stock is usually held against the edge of the workpiece and either side of the tongue is then used as a straight edge for making a mark, or as a reference to check the accuracy of an angle. [7] [2]

7. Combination square - Wikipedia

   en.wikipedia.org/wiki/Combination_square

   The centre finder head has two faces meeting at 90°, when attached one edge of the rule bisects the two faces at 45°. The heads are manufactured from either forged steel, cast iron, die-cast aluminium, die-cast zinc, or plastic. Aluminium and zinc heads are cheaper than steel and iron, but less durable and more prone to inaccuracy. [5]