Search results
Results from the WOW.Com Content Network
Conversely, a current source provides a constant current, as long as the impedance of the load is sufficiently lower than the current source's parallel impedance (which is preferably very high and ideally infinite). In the case of transistor current sources, impedances of a few megohms (at low frequencies) are typical. Because power is current ...
A Widlar current source is a modification of the basic two-transistor current mirror that incorporates an emitter degeneration resistor for only the output transistor, enabling the current source to generate low currents using only moderate resistor values.
In electronics, a constant current system is one that varies the voltage across a load to maintain a constant electric current.When a component is indicated to be driven by a constant current, the driver circuit is, in essence, a current regulator and must appear to the component as a current source of suitable reliability.
Load regulation of a constant-voltage source is defined by the equation: [3] % = % Where: is the voltage at maximum load. The maximum load is the one that draws the greatest current, i.e. the lowest specified load resistance (never short circuit);
Consider an active network containing impedances, (constant-) voltage sources and (constant-) current sources. The configuration of the network can be anything. Access to the network is provided by a pair of terminals. Designate the voltage measured between the terminals as V θ, as shown in the box on the left side of Figure 2. Fig. 2.
This is the only first order source of mismatch in the three-transistor Wilson current mirror [8] Second, at high currents the current gain, β, of transistors decreases and the relation of collector current to base-emitter voltage deviates from = (). The severity of these effects depends on the collector voltage.
A current mirror is a circuit designed to copy a current through one active device by controlling the current in another active device of a circuit, keeping the output current constant regardless of loading. The current being "copied" can be, and sometimes is, a varying signal current.
The term DC is used to refer to power systems that use only one electrical polarity of voltage or current, and to refer to the constant, zero-frequency, or slowly varying local mean value of a voltage or current. [9] For example, the voltage across a DC voltage source is constant as is the current through a direct current source.