Search results
Results from the WOW.Com Content Network
The machine tool division was sold to fellow Rockford company Bourn & Koch, who provides parts, service, and support for their machines to this day. Barber–Colman henceforth focused on cutting tools and process controls. The remaining divisions were eventually sold off. The Barber–Colman trademark is held by Eurotherm Controls, Inc.
Duct leakage test in the US. A duct leakage tester is a diagnostic tool designed to measure the airtightness of forced air heating, ventilating and air-conditioning (HVAC) ductwork. A duct leakage tester consists of a calibrated fan for measuring an air flow rate and a pressure sensing device to measure the pressure created by the fan flow.
Kitchen exhaust cleaning (often referred to as hood cleaning) is the process of removing grease that has accumulated inside the ducts, hoods, fans and vents of exhaust systems of commercial kitchens. Left uncleaned, kitchen exhaust systems eventually accumulate enough grease to become a fire hazard.
A gas duster, also known as tinned wind, compressed air, or canned air, is a product used for cleaning or dusting electronic equipment and other sensitive devices that cannot be cleaned using water. This type of product is most often packaged as a can that, when a trigger is pressed, blasts a stream of compressed gas through a nozzle at the top.
This suction pressure operates to cause suction pressure collapse on the duct side walls. Also this pressure operates perpendicular to the duct "expansion joints" to create an additional load on the duct supports that adds to dead, and live loads. Please note: duct pressure loads vary with temperature, as the gas density varies with temperature.
Barber realized that the mixing and placing operations needed to be separated, and the mixing section became the line of Barber Greene asphalt plants and the placing section became the Barber Greene paver line. The early pavers used screw conveyors to distribute the mix in front of a screed that tamped the mix. This process meant that the ...
A diffuser is "a device for reducing the velocity and increasing the static pressure of a fluid passing through a system”. [1] The fluid's static pressure rise as it passes through a duct is commonly referred to as pressure recovery. In contrast, a nozzle is used to increase the discharge velocity and lower the pressure of a fluid passing ...
There are two major systems to classify ductwork airtightness, one based on European standards, the other based on ASHRAE standard 90.1-2010.Both are based on the leakage airflow rate at a given ductwork pressure divided by the product of the ductwork surface area and the same ductwork pressure raised to the power 0.65.